ZS-50W CO2 laser power supply

Feature：

1. Good compatibility: This PWM/0-5V laser power supply can match with most brand 1000mm 50W CO2 laser tube and it also has a strong adaptability and fast response, engraving, cutting advantages of good effect.

2. Control is simple: This co2 laser power supply selects high or low level control, the use of TTL-level control of the laser can start and stop. At the same time it increases the protection switch, testing is through the external water and ventilation on this PWM/0-5V laser power source.

3. Laser power control is simple on this 50w laser power supply, you can use 0 ~ 5V analog signal control the laser power, you can also use the PWM (pulse width modulation) signal to control output laser power.

4. This 50w laser power supply has stable performance: Each  co2 power supply has been much more rigorous testing procedures, under full load high temperature (52~55 degrees Celsius) 24 hours of aging, to ensure the stability of each50w laser power supply.

5. This ZS-50WG CO2 power supply adopts G/P/L/G/IN/5V as control signal output port with 5V/24V output and use gray aluminum case.

6. Protection function: This PWM/0-5V laser power supply has open circuit protection: Under the condition of good protective earth, the50w laser power supply can work in open-circuit for a short time, which could avoid the damage to this PWM/0-5V laser power supply.

10. It adopts silicone tube to wrap output HV cable  to prevent electric sparks from splashing and protect operators and equipment, which allowing laser power supply work normally in humid environments

11. 90-270V Voltage stabilizer is optional.

Specification：